Wiring · Greater Noida, Uttar Pradesh
Wiring in Greater Noida
Almost all wiring work here is adding dedicated circuits rather than replacing anything. Flats were handed over with modest circuit counts and frequently unlabelled boards, so the first job on many visits is labelling the board — which turns every future fault from a search into a lookup.
- Greater Noida price from
- ₹320
- Areas covered
- 9
- Guarantee
- 30 days
Why Greater Noida is different
Electrical work in Greater Noida
Greater Noida's high-rise flats were handed over with modest circuit provision and frequently unlabelled distribution boards, so the first fault takes far longer to trace than it should. Second air conditioners and kitchen appliances added since generally share existing ways. In the plotted sectors, houses that added floors did not revisit the board or the sanctioned load.
Wiring is the one job where cutting corners stays hidden until it is expensive. Most of what we see in NCR homes is not dramatic — it is a 1990s flat carrying four air conditioners on cable sized for two ceiling fans and a tube light. Our electricians size the cable to the actual load, keep circuits separated, and leave you a layout you can hand to the next person who opens the wall.
Common problems
Wiring faults we see most in Greater Noida
Each one written the way a customer describes it, with the cause behind it.
“Sockets get warm, or a plug top discolours”
Usually because: Undersized cable or a loose termination heating under load. This is the stage before a burn mark, and it is worth acting on immediately.
What we do: Circuit is re-cabled to the correct size and every termination on the run is re-made.
“Lights dim whenever the fridge or AC compressor kicks in”
Usually because: Lighting and power sharing one overloaded circuit, so the inrush current drags the voltage down across both.
What we do: Lighting is split onto its own circuit at the distribution board.
“A mild tingle from a tap, geyser body or appliance casing”
Usually because: A missing or broken earth. Common in older Delhi colonies where the original earthing pit was never maintained.
What we do: Earth continuity is traced end to end and the earth conductor restored or re-run.
What the booking includes
- Load assessment for the room or the whole flat before any cable is pulled
- ISI-marked FR / FRLS copper cable, sized to the circuit
- New light, fan, 5A and 16A power points
- Concealed conduit runs, or surface casing where chasing is not permitted
- Separate circuits for heavy loads — AC, geyser, microwave
- Continuity, polarity and earth-continuity testing before handover
What it does not cover
Listed so nothing appears on the bill that was not discussed up front.
- Wall chasing repair, plaster and paint finishing
- Switch plates and modular fittings unless quoted separately
- Society or RWA permissions for common-area work
Pricing
Wiring charges in Greater Noida
Indicative Greater Noida rates for a normal job.
| Job | Indicative price |
|---|---|
| New light / fan point | ₹320 – ₹600per point |
| New 16A power point (AC, geyser) | ₹550 – ₹1,100per point |
| Concealed rewiring, 2 BHKVaries most with cable size and how many points you keep versus add. | ₹16,560 – ₹34,960 |
| Concealed rewiring, 3 BHK | ₹25,760 – ₹50,600 |
| Fault finding / open-circuit tracing | ₹460 – ₹1,100per visit |
| Earthing check & restoration | ₹740 – ₹2,300 |
These are indicative ranges for typical jobs, not quotes. You see the actual price for your job before you confirm the booking. A visiting charge of ₹99–₹149 applies where an inspection is needed, and it is adjusted against your final bill. Materials are billed separately and itemised on your digital invoice. Greater Noida runs about 8 percent below the NCR baseline — shorter distances, free parking and simpler society entry mean less time is spent around the job. The exception is hard-water work: descaling and tank cleaning are needed more often here than elsewhere in NCR, so the annual spend on plumbing maintenance can be higher even though each visit costs less.
Coverage
Areas we cover for wiring in Greater Noida
Each area has its own page with the local housing stock, common faults and what they mean for this job.
Before we arrive
A few things that make the visit faster
- Note which points are dead or unreliable — it speeds up fault tracing a lot
- Clear wall access along the run where possible
- Check whether your society requires prior intimation for drilling hours
Also searched as
Looking for wiring in Greater Noida? People across Delhi NCR also ask for this as wiring wala, bijli ki wiring, house rewiring or new point wiring. You can book in whichever words are natural to you — our support team works in Hindi and English, and so do the professionals who take the job.
FAQs
Wiring in Greater Noida — common questions
How do I know if my flat actually needs rewiring?
Warm sockets, browning around switch plates, an MCB that trips more often than it used to, or a tingle from an appliance body are all signs the wiring is past its comfortable load. Age matters too: aluminium wiring, common in NCR flats built before the mid-1990s, becomes brittle at terminations. An electrician can test rather than guess, and a fault-finding visit costs a fraction of a rewire.
Will you break my walls?
Concealed wiring means chasing channels into plaster, so yes, there is cutting where the run goes. We keep it to the marked route, cut dry where possible to limit dust, and leave the conduit ready for your mason. If you would rather not open walls at all, surface casing-capping is a legitimate option and we will price both.
What cable do you use?
ISI-marked FR or FRLS copper, sized to the circuit — typically 1.0 sq mm for lighting, 1.5 sq mm for fan and 5A points, 2.5 sq mm for general power, and 4 sq mm for air conditioners and geysers. We do not use aluminium for internal wiring, and we do not down-size to save on material.
Related
Other jobs we do in Greater Noida
- MCB Repairs in Greater NoidaTripping MCBs, DB faults & load issues diagnosed and fixed.
- Switch Replacement in Greater NoidaFaulty switches, sockets & modular plates swapped same day.
- Inverter Setup in Greater NoidaInverter & battery installation, wiring and backup load planning.
- All electricians in Greater NoidaBackground-verified electricians across Delhi NCR for fans, wiring, switchboards, MCBs and inverters — with upfront pricing and a 30-day guarantee.
Other cities
Wiring elsewhere in Delhi NCR
Book wiring in Greater Noida
Verified professionals, upfront pricing from ₹320, and a 30-day guarantee on eligible work.